GENERAL INSTALL
​
1. When fastening directly into wood use a minimum of a #12 screw & washer. Screw length will vary depending on the application. Drilling a small pilot hole is recommended.
​
2. If fastening with a bolt, use a minimum of a 1/4” bolt, washer & nut. The mounting hole on “The HOOKIT” will accommodate up to a 5/16” bolt. Bolt length will vary depending on the application. Drilling a small pilot hole is recommended.
LAWNMOWER INSTALL
​
1. “The HOOKIT” can be installed between the existing handle locking knob and the handle
frame.
2. Most models come with a 1/4” hole, in the handle, directly from the factory. If your mower doesn’t have this, simply drill a 1/4” hole through handle. When assembling the bolt & lock nut, tighten for a snug fit that still allows The HOOKIT to move/swing with some resistance.
GRILL INSTALL
​
Locate an area that is flat (usually below a shelf) & where you can easily access the trigger spray bottle. Drill 1/4” hole in the thin sheet metal no more than 1” from the bottom. This will allow “The HOOKIT” to hang properly. Use the bolt, washer & lock nut provided.
_edited.jpg)
